Common Faults And Solutions Of Double Shaft Shredder

The double shaft shredder does not work

The power supply voltage is too high or too low: Check whether the voltage is normal.

The wire is broken, the connector and the terminal are detached: Repair the broken wire and tighten the terminal.

The main power supply is not connected: Check whether the main power supply is connected.

The thermal relay is disconnected due to overload: Reset the thermal relay.

The fuse is burned out: Replace the fuse.

There are many hard objects in the material: Install auxiliary equipment to remove hard objects.

The blade material is not good: Use the original tool or replace the high-quality tool.

Check whether metal is accidentally thrown into the feed hopper: Stop the machine and remove the metal.

Check whether the bearing is damaged: Stop the machine and replace the bearing.

The moving knife hits the fixed knife plate: Adjust the distance between the moving knife and the fixed knife plate.

A part is loose: Check and tighten the loose parts.

The equipment stops due to overload: Clear the material in the equipment, start it manually in reverse, and then start it in forward direction.